Next time it will point right at the 12 mark when it chimes. Hold knob still this still with fingers while turning the minute hand to the top of the hour. Locate the circle hand setting knob on the back of the movement. Given these points, if the minute hand will not point exactly on the top of the hour, here is the correction. Take the minute hand off the clock and reinstall to point close to the 12. Point the hour hand to whatever hour it rang out. In conclusion, to complete the chime quartz movement installation, turn the minute hand to make it chime and strike out the hours. Use fingers to push it onto the pin that is in the center of the post. Second handĪdditionally, if there is a second hand this goes on just by a friction fit and this would be last. Therefore, the minute hand needs the nut to secure it. The minute hand has an oblong hole and mounts onto the oblong shaft at the end of the unit. All it needs is just a twist and push motion. Know the names of the parts is always helpful in completing a quartz movement installation. A clock dial is the part with the hands and numbers on it and is also called a clock face. Install the brass washer and hex nut on next to secure the movement to the back of the clock dial. The post goes through the back of the dial toward the front. The separate hanger is how the QU22 is shipped, where as the QU30 has it molded as part of the movement, and QU40 does not get one. Both go over the post that sticks out the front of the movement. Hanger goes on the new movement first if there is one, and then the rubber washer. Installation of the chime quartz clock movements is done in the following sequence. Therefore, the individual instructions need to be read for this information. However, each unit is varied with the chime functions and speaker style. The following is the basic installation for a chiming quartz movements from Clockworks.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |